The MDC100-050101USB controller is a Programmable Proportional, Integrator (PI) Controller designed to drive DC Brushless motors at currents of up to 10A (peak) and 50V. Included on the driver is an internal potentiometer to control the maximum phase current allowed into the motor. The driver is protected against over current (cycle-by-cycle), hall sensor error and under voltage. When an error occurs, a fault light is turned on to notify the user.

Need to know the RPM of your motor? Check out our new SPDRO-4 speed readout module.

Keep your input voltage from rising too high due to internal mismatches while running your BLDC motor with our new PWR-24V/48V CLAMP active crowbar circuit.